Operations Procedures
1. Confirm that accelerator pedal is fully released, turn ignition switch “ON” and wait 3 seconds.
2. Repeat the following steps (2a and 2b) procedures quickly five times within 5 seconds.
2a. Fully depress the accelerator pedal (HARD).
2b. Fully release the accelerator pedal.
3. Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. 10 seconds until the CEL starts blinking.
4. Fully release the accelerator pedal (while the CEL is still blinking)
5. Wait about 10 second.
6. Fully depress the accelerator pedal and keep it for more than 10 seconds.
7. Fully release the accelerator pedal (The CEL light will continue to blink).
8. Turn ignition switch to “OFF” position and now you can start the car. The CEL light should be gone.
If the CEL light continues to remain ON, repeat the above steps. Timing is EXTREMELY critical to resetting the ECU.
ne pas appuyer sur les pedales, puis :
tournez la clé de contact sur on, attendez 3sec
appuyez 5x sur la pedale d'accelerateur a fond, rapidement, en relachant apres chaque appui: phase d'appui+relachement en 1sec, le tout prend donc 5sec
attendez 7sec, puis appui maintenu a fond sur pedale accelerateur pendant env 10sec : jusqu'a ce que le voyant moteur du tableau de bord commence a clignoter.
relachez la pedale d'accelerateur pendant que le voyant clignote
attendez 10sec
appuyez sur la pedale d'accelerateur pendant + de 10sec
relachez, le voyant clignote toujours
tournez la clé position OFF, puis demarrez (vroum-vroum : le voyant ne clignote plus du tout, si c tjs le cas, recommencez. Le chronometrage doit etre rigoureusement respecté)
ENJOY (si vous avez des modifs, si vous avez fait de longs trajets, de la ville: des parcours encrassants...)